Ford Mondeo 2 P1629 Engine Trouble Code

Powertrain Code P1629

What is Ford Mondeo 2 P1629?

Ford Mondeo 2 P1629 indicates potential catalytic converter failure. If completely failed, your vehicle may not run properly and fuel economy will suffer significantly. Average replacement cost is $2,000–$2,140. This repair requires professional service and should not be delayed.

P1629 on the Ford Mondeo 2

The Ford Mondeo 2 features a sequential multi-port fuel injection (SMFI) system where injector timing is tightly synchronised with the crankshaft signal. Wear on the crankshaft reluctor ring teeth produces signal dropout events that accumulate and eventually trigger P1629.

P1629 Ford Mondeo 2 Engine Diagram

Code Information

Code Type:OBD-II Powertrain (P) Trouble Code
System:Powertrain
Vehicle:Ford Mondeo 2
Brand:Ford
Model:Mondeo 2
Code:P1629

P1629 Ford Mondeo 2 Symptoms

⚠️

Check Engine Light

Illuminated Ford Mondeo 2 dashboard warning

🔧

Engine Stalling

Engine stops unexpectedly or misfires

Performance Issues

Reduced power or acceleration on the Ford Mondeo 2

🚫

Starting Problems

Difficulty starting the engine

Poor Fuel Economy

Increased fuel consumption on the Ford Mondeo 2

💨

Increased Emissions

Failed emissions test due to P1629

P1629 Code Structure

Understanding what each digit means in the P1629 powertrain trouble code:

P 1 6 2 9
Powertrain Code Fuel And Air Metering Fuel Temperature Sensor B Circuit Range/Performance Turbocharger Boost Sensor A Circuit Low Reverse Input Circuit

How to Fix Ford Mondeo 2 P1629

Diagnostic Steps:

The catalytic converter has oxygen sensors before and after it. When warm and in closed-loop mode, the upstream O2 sensor reading should fluctuate, while downstream should remain steady.

Repair Solution:

VSS concerns may stem from noisy input signals caused by RFI/EMI from ignition wires, charging circuits, or aftermarket equipment. Verify VSS reads 0 mph when transmission is in Park.

Technical Notes:

P1629 DTC specifically relates to camshaft timing. When cam timing is over-retarded, the check-engine light illuminates and this code sets. Verify VCT solenoid operation and check for contamination.

Ford Mondeo 2 P1629 Repair Cost

For Ford Mondeo 2 owners, budget the following for a P1629 repair: EGR valve cleaning $80–$120 or replacement $250–$450, intake manifold gasket $120–$200, and a post-repair reset and road test. Total: $350–$650 at an independent garage.

P1629 Description

P1629 engine trouble code is related to Reverse Input Circuit.

Main Cause

The primary reason for P1629 OBD-II Engine Trouble Code is: Fuel Temperature Sensor B Circuit Range/Performance.

Common P1629 Misdiagnosis on the Ford Mondeo 2

Fuel injector replacement is over-prescribed on the Ford Mondeo 2 for P1629 when the actual fault is a weak fuel pump. Low fuel rail pressure causes lean misfire that looks identical to injector failure in static scan data without a live fuel pressure test.

DIY Repair Guide: P1629 on Ford Mondeo 2

The throttle body on the Ford Mondeo 2 can be cleaned without full removal. Use a clean rag and throttle body cleaner spray with the engine off and cool. After cleaning, an idle relearn is mandatory: disconnect the battery for 10 minutes, reconnect, and allow the engine to idle for 10 minutes undisturbed.

Preventing P1629 on the Ford Mondeo 2

The Ford Mondeo 2 heat shield over the exhaust manifold protects the nearby sensor wiring from radiant heat damage. Inspect it for cracks or displacement at every brake service. A $15 replacement shield can prevent $300+ wiring loom repairs.

Frequently Asked Questions — Ford Mondeo 2 P1629

Q: Is P1629 covered by Ford Mondeo 2's manufacturer warranty?
A: If your Ford Mondeo 2 is within the factory powertrain warranty period (typically 3–5 years or 60,000–100,000 miles depending on region and generation), P1629 repairs caused by component defects should be covered. Bring your service history to the dealer appointment.

Search Another Code