Suzuki Splash P1629 Engine Trouble Code
What is Suzuki Splash P1629?
Suzuki Splash P1629 code can indicate a faulty oxygen sensor, which may eventually damage the catalytic converter (repair cost: $2,000–$2,200). Professional diagnosis costs around $200–$210. Oxygen sensors are often straightforward to replace — check your owner's manual for location and instructions. This issue should be addressed promptly to prevent further damage.
P1629 on the Suzuki Splash
Owners who tow regularly with their Suzuki Splash should pay extra attention to P1629. The additional thermal load placed on the transmission fluid accelerates the degradation of the torque converter clutch solenoid, a frequent secondary cause of this code.
Code Information
| Code Type: | OBD-II Powertrain (P) Trouble Code |
| System: | Powertrain |
| Vehicle: | Suzuki Splash |
| Brand: | Suzuki |
| Model: | Splash |
| Code: | P1629 |
P1629 Suzuki Splash Symptoms
Check Engine Light
Illuminated Suzuki Splash dashboard warning
Engine Stalling
Engine stops unexpectedly or misfires
Performance Issues
Reduced power or acceleration on the Suzuki Splash
Starting Problems
Difficulty starting the engine
Poor Fuel Economy
Increased fuel consumption on the Suzuki Splash
Increased Emissions
Failed emissions test due to P1629
P1629 Code Structure
Understanding what each digit means in the P1629 powertrain trouble code:
| P | 1 | 6 | 2 | 9 |
|---|---|---|---|---|
| Powertrain Code | Fuel And Air Metering | Fuel Temperature Sensor B Circuit Range/Performance | Turbocharger Boost Sensor A Circuit Low | Reverse Input Circuit |
How to Fix Suzuki Splash P1629
Diagnostic Steps:
Regarding P1629, carefully inspect the wire harness near the intake manifold bracket, best accessed from below near the oil filter. Look for chafing, pinching, or damaged insulation.
Repair Solution:
A/C pressure sensor monitors refrigerant pressure changes. DTC sets when pressure change falls outside calibration. Verify A/C system function, refrigerant charge, and electrical connections.
Technical Notes:
For P1629, verify VCT solenoid operation. Look for stuck or sticking valves caused by contamination. Consult vehicle-specific repair manual for proper component testing procedures.
Suzuki Splash P1629 Repair Cost
Fuel injector cleaning service on the Suzuki Splash costs $150–$300 for an ultrasonic bench-clean of all injectors with flow-test certification. On-car induction cleaning is a cheaper ($80–$120) first step but is less thorough for heavily fouled injectors.
P1629 Description
P1629 engine trouble code is related to Reverse Input Circuit.
Main Cause
The primary reason for P1629 OBD-II Engine Trouble Code is: Fuel Temperature Sensor B Circuit Range/Performance.
Common P1629 Misdiagnosis on the Suzuki Splash
Some Suzuki Splash models have a known software bug where the PCM flags P1629 after battery disconnection and reconnect. Always perform an ECU adaptation reset and drive cycle before ordering any parts following battery work.
DIY Repair Guide: P1629 on Suzuki Splash
The coolant temperature sensor on the Suzuki Splash is a straightforward DIY item (difficulty 2/5). Have a drain tray ready for the small amount of coolant that spills when the sensor is removed. Top up the cooling system afterwards and check for air pockets.
Preventing P1629 on the Suzuki Splash
For turbocharged Suzuki Splash models, allowing the engine to idle for 60–90 seconds before shutdown after hard driving reduces turbocharger heat soak and prevents the coking of oil that blocks VVT galleries — a known secondary trigger of P1629.
Frequently Asked Questions — Suzuki Splash P1629
A: Simple fixes like a purge valve or gas cap replacement take under an hour. Sensor replacements typically require 1–2 hours of shop time. More involved repairs like VVT actuators or catalytic converters may require a full day or more.